Contact Us

Jasper Electronics Co.,Ltd

Add:2th Floor, No.3, Xinyuan North #2 Road, 
Ludong, Humen, Dongguan 523935, China

Tel:0769-84750145 , 23010026

Fax:0769-84750145 ext 802


Membrane Switch Viscose Layer

- Nov 07, 2017 -

Membrane switchIs composed of multilayer film adhesive as a whole, so it has a few thin film will need to have several layers of adhesive.At presentMembrane switchThe manufacturing process of doublestickersHas a downward trend for the application of the media, the interlining part has been gradually replaced by "sandwich" prefabricated interlayer, the panel and the bottom layer of adhesive, adopt the method of screen printing emulsion for rubber is on the development trend.Screen printing emulsion with double-sidedstickersEquivalent viscosity, but the cost is low, bonding process won't produce bubbles, surface is flat and level.Especially in the application of panel layer, can be controlled by printing emulsion area graphics, avoid the window, hole site need to get rid of the trouble respectively.

Screen printing emulsion process should pay attention to the following aspects:

1. The coarse mesh.Only the coarser mesh, conducive to the smooth paste emulsion through, general appropriate chooses 60 a 80 mesh coarse mesh.

2. Water resistance.Due to screen printing latex is a water-soluble gel, emulsion containing a large number of moisture, if the usual oil resistance photosensitive film, graphics easy damaged, water resistance photosensitive plastic plate should be adopted.If every sensitive glue water resistance, should be made on the screen, using water resistant coating protection graphics, because of its method is more, from here.

3. Thick film layer.Thicker coating membrane layer, especially in the network version of the printing film layer is much thicker than the scraping the mask layer is, the general should guarantee the wet thickness was printed in 80 ~ 80 microns.

4. The orange peel.Membrane switch viscose layer 

Related Products