Categories

Contact Us

Jasper Electronics Co.,Ltd

Add:2th Floor, No.3, Xinyuan North #2 Road, 
Ludong, Humen, Dongguan 523935, China

Tel:0769-84750145 , 23010026

Fax:0769-84750145 ext 802

Phone:+8617322151103

E-mail:sales@jasperele.com

E-mail:sales05@membraneswitch.co

Web:www.jasperele.com

Where should the finished product of the membrane switch be tested for compliance?

- Aug 31, 2018 -

Where should the finished product of the membrane switch be tested for compliance?


The membrane switch is composed of a panel, an upper circuit, an insulating isolation layer and a lower circuit, so the membrane switch can also be called a membrane switch panel. Under normal circumstances, the two contacts of the membrane switch are in an open state, and when an external force is applied to the membrane switch, the two normally open contacts are momentarily turned on. After the external force disappears, the switch contacts return to the normally open state. Usually the circuit contacts are from the drum or the pot is added (good feel). When the membrane switch is pressed, the upper circuit contact is deformed downward, and is in contact with the plate of the lower circuit. After the finger is released, the upper circuit contact bounces back, the circuit is disconnected, and the circuit triggers a signal. The Haiwen membrane switch has a rigorous structure, beautiful appearance and good sealing performance. It has anti-moisture and long service life (up to 1 million times). Widely used in electronic communications, electronic measuring instruments, industrial control, medical equipment, automotive industry, instrumentation, household appliances, military equipment and other fields.


The finished product of the membrane switch should be qualified according to the following aspects:

Combined state: There must be no residual material scraps, foreign matter, stains, bumps and grease attached to the surface and inside, fingerprints on the line, and burrs on the shape.


Injuries: All lines and joints must not have cuts through the table (ie the cuts are cut from the line to the substrate). Slight scratches are also based on the principle that the impedance is not affected. The surface of the carbon ink is extremely susceptible to scratches, and the scratches are not affected by the line conduction.


Foreign objects: The line must not have any foreign objects attached to it.


Material: Substrate, silver paste, carbon ink, separator, adhesive, adhesive, reinforcing plate, and insulation printing shall comply with the drawings.


Shape: shape, conductor circuit, insulation treatment, lining combination, etc. should comply with the drawings or provide physical samples.


Related Products