Categories

Contact Us

Jasper Electronics Co.,Ltd

Add:2th Floor, No.3, Xinyuan North #2 Road, 
Ludong, Humen, Dongguan 523935, China

Tel:0769-84750145 , 23010026

Fax:0769-84750145 ext 802

Phone:+8617322151103

E-mail:sales@jasperele.com

E-mail:sales05@membraneswitch.co

Web:www.jasperele.com

Thin film materials used in the panel and characteristics

- Mar 28, 2018 -

Applicable to the production of membrane switch panel substrate with PC, PVC, PET, such as:

Polycarbonate film (PC)

PC material has the distinguish of sand surface and smooth surface, PC material physical properties and chemical properties of composite indicator is good, the adaptive ink more widely, also isMembrane switchpanelLayer of the most common material.Polycarbonate film with large temperature range (135 ~ 135 ℃), when the temperature or humidity changes, the performance of this kind of material change is not big, to ensure that the panel can be used in all kinds of instruments, all kinds of bad environment.The solvent is more sensitive, but the downside is strong solvation effect of solvent easily embrittlement, crack.

Polyvinyl chloride (PVC) film

PVC film material's price is lower, about half of PC material, when the product in the production of civil affordable, if choose PVC material, can reduce the production cost, PVC material has good ductility at the same time, can use cold processing three-dimensional graphic.Made from polyvinyl choride (PVC) heat resistance performance is poorer, especially under the condition of high temperature, the softening temperature of 59 ℃, elastic than polycarbonate film well.But it has the high elongation rate (130%), and because of its low price, it is suitable for use in general conditions.

Polyester film (PET)

PET filmSurface state, are generally smooth transparent membrane, a few have the sand surface products such as the condition of the Japanese Kimoto KB products of the company.Elasticity of polyester film and temperature resistance are good, the price between the polycarbonate film and PVC film.But because of the thin film surface is difficult to processed into matte texture, more transparent sheet, at the same time, the surface of the polyester film for the vast majority of plastic cannot obtain the satisfactory result of printing ink, general to specific use special inks, to ensure good follow-up processing performance.Because of PET film general performance can be replaced by PC film, so the material used for panel is not too much, unless in some special occasions, such as the insulation, the springback, solvent resistance is under the condition of other film can't meet only a small number of applications.



Related Products