Contact Us

Jasper Electronics Co.,Ltd

Add:2th Floor, No.3, Xinyuan North #2 Road, 
Ludong, Humen, Dongguan 523935, China

Tel:0769-84750145 , 23010026

Fax:0769-84750145 ext 802


Four aspects of membrane switch quality testing

- Apr 18, 2018 -

Membrane switch quality testing is a very important work, establish a set of perfect quality assurance system, for a successful film switches enterprises is a vital priority. In the quality inspection of membrane switch. In addition to care about screen printing workers is very familiar with the ink color rendering and the customer's color reproducibility, more important still need to pay attention to the inner quality of membrane switch, such as keystrokes, life-span, peel strength, and high temperature, low temperature, constant temperature hot and humid and loop electric Yin, electrical insulation Yin, withstand voltage test indexes such as.

1. The membrane switch testing technical requirements

The appearance quality of inclusions, uneven inclusion, less than 2 / dm squared. The length of the inclusions, spots is not more than 1 mm. Not allowed to accumulate, at least 50 mm apart scratches; Scratch is less than 1 / dm squared, the length of the scratch is not more than 20 mm, the depth and width is not more than 50 um; Depth is not more than 1 um scratches are allowed.

2. Color

With batch of products should be no obvious difference color, color printing layer be hiding power, enough to reflect light observation can't see the following colour and structure; Printing transparent ink layer, double color overlap must not exceed 1 mm, the resulting color deviation is allowed. Printing characters and the edge of the patch is not clear is not greater than 0.15 mm.

Size 3.

The size of the membrane switch shall comply with the terms of table 1, membrane switch and parallelism of two adjacent side has verticality should comply with the provisions, tape the center distance between adjacent wire end of average of 2.54 mm.

4. The peel strength

Membrane switch the peel strength of adhesive layer should not be less than 8 n / 25 mm.

Related Products